Zanussi ZCF 57 installation manual Something not Working, Symptom, Solution

Something not Working

Before: contacting your local Service Force Centre check the following point.

IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.

SYMPTOM	SOLUTION
No power to the appliance (green light off)	Check there is power at the socket
	Check there is not a power cut by checking the
	household lights.
	Check the mains fuse has not blown.
The temperature in the freezer is too warm (red light on)	Check the thermostat control knob is turned to the
	correct setting relevant to ambient conditions.
	Check the ambient temperature is within the
	appliance's operating limits of 10° to 32°C.
The freezer lid will not open	Has the lid just been opened? If so leave for a few
	minutes to allow the air pressure to equalise.
	Adjust the thermostat control knob to give correct
	temperature control. See 'Temperature Control'.
Excessive frost and ice has built up	Check that the lid is closed.
	Large quantities of food have recently been placed in
	the cabinet/and or the lid is frequently opened.
	Check that air ventilation is not obstructed.
	Ensure the lid has not been left open.
	Check that nothing is preventing the lid from closing.
	Is the lid gasket intact and clean?
	Has advised periodic cleaning been carried out.
Noise	Refer to 'Normal Operating Sounds'

If after all above checks there is still a fault, call your local Service Force Centre.

In-guarantee customers should ensure that the above checks have been made, as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

Please note that proof of purchase is required for any in-guarantee service calls.

11