Before the First Use of the Cooker
INSTALLATION
Any gas installation must be carried out by a CORGI registered installer, and in accordance with existing rules and regulations.
The relevant instructions are to be found in the second section of this manual.
Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event of a breakdown.
WHEN THE COOKER IS FIRST INSTALLED
Once the cooker has been installed, it is important to remove any protective materials, which were put on in the factory.
Remove all packaging, both inside and outside the cooker, before using it.
Before first use, the oven should be heated without food.
During this time, an unpleasant odour may be emitted.
This is quite normal.
1.Set the electronic timer to manual function.
2.Switch the oven function control knob to fan cooking
.
3.Set the thermostat control knob to MAX.
4.Open a window for ventilation.
5.Allow the oven to run empty for approximately 45 minutes.
This procedure should be repeated with the grill function for approximately
Controls
Hob burners
ΦTo light a burner:
-turn the relevant control knob anticlockwise to maximum position.
-At the same time push the electric ignition button which is marked with a little spark.
-Then adjust the flame as required.
If the burner does not ignite, turn the control knob to zero, and try again.
When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated automatically.
If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the pan, causing the handle to overheat.
6