Zanussi ZCM 700 X manual Installation, Connecting to Gas

Installation

IMPORTANT

This cooker must be installed by qualified personnel to the relevant British Standards.

Any gas installation must be carried out by a registered CORGI installer.

The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored.

Connecting to Gas

This cooker is designed to be installed with an appliance flexible connection. Connection is made to the RC 1/2 (1/2" B.S.P.) threaded entry pipe located just below the hotplate level on the rear right-hand side of the cooker.

Asecond entry pipe is located on the rear left-hand side and it is locked by a security nut. Should this second entry pipe allow a safer gas connection, remove the security nut and the relevant gasket from the left-hand entry pipe and place it onto the main entry pipe, ensuring the gasket is correctly positioned and the nut is well secured.

When the final connection has been made, it is essential that a thorough leak test is carried out on the cooker and installation. Ensure that the main connection pipe does not exert any strain on the cooker.

Note:

For certain types of gas bayonet connection used, it may not be possible for the appliance to be pushed fully back to the wall stops.

Important:

Flexible tubing MUST comply with BS.669 Current Edition.

FO 0264

A)End of shaft with nut

B)Washer

C)Elbow

27