The furniture door
The door on this appliance is designed for the overlay of a panel having the following dimensions:
Width | 596 mm |
Height | 604 mm max |
Thickness | 20 mm max |
Weight | 2 - 7.5 kg max |
The height of the panel depends on the height of adjacent kitchen units (see kitchen plinth adjustment).
The panel height should be no more than indicated, otherwise complete opening of the door will not be possible as the furniture door panel will hit against the dishwasher plinth.
Furtermore, it is possible to line up the control panel to correspond with the height of the drawers of adjacent pieces of furniture, thus perfectly
Add one or more of the fillets provided until you reach the desired height.
Secure the fillets as shown in the picture, by means of two screws 4 x 40 provided therewith.
Prepare the panel as follows:
1.Measure the distance (B) between the part below the control panel (or fillets) and the reference notch
(X) on the door.
2.Drill the panel with a Ø 2 x 14 bit according to the dimensions given in the picture.
3.Screw the two fastening pivots into the holes indicated in the picture.
4.Mount the decor panel by inserting the two fastening pivots into the slotted holes of the door. Lift the decor panel until perfect alignment with the fascia panel is obtained.
5.Once the correct position has been found, open the door and fasten the decor panel by means of the four 4 x 40 screws provided, using the holes through the inner door.
A
A
II04 |
|
|
|
| B |
1 |
| X |
|
| |
= |
| B |
553 |
| |
| = | |
|
| |
II113 |
| 2 |
|
|
II83 |
II84 |
24 | INS23en |
