Zanussi ZDB 5377 W manual 8START/PAUSE button, Indicator Lights

•Incorrect option selection

If you select an option that is not compatible with the programme you have selected, the display shows Err (error).

Important!

After emptying the water reservoir following a full tank light, there may be a short delay before the machine will re-start to allow the system to re set.

This code will reappear during the execution of the programme if you press one of the option buttons or turn the programme selector.

•Alarm code

In the case of a functional problem, the display shows an alarm code (e.g. E21). See page 13 for more detailed information.

E21

8START/PAUSE button

Press this button to start the dryer after having selected the programme and the options.

The relevant light will stop flashing. If you have chosen a delayed start, the machine will begin the countdown.

If the door of the appliance or the small door at the bottom is opened while the programme is running, this button must be pressed again after closing the door in order to restart the programme from the point at which it was interrupted.

This button must also be depressed after a power failure and after having re-inserted the water reservoir, if it has been emptied in the middle of a programme after lighting up of the “FULL TANK” light.

In both cases the light of the Start/Pause button flashes to remind you that the start button needs to be pressed again.

9 Indicator Lights

These lights indicate the following functions:

“DRYING” light

This light indicates that the appliance is in the drying phase.

“COOLING” light

This light indicates that the appliance is in the cooling phase. At the end of drying, there is a 10 minute cooling phase to cool the laundry.

“END” light

This light is on at the end of the cooling phase, during the anti-creasing phase and at the end of the programme.

“CLEAN FILTERS” light

This light illuminates at the end of the programme to remind you that the filters must be cleaned.

“FULL TANK” light

This light comes on at the end of the programme to remind you that the water reservoir must be emptied out. If this light illuminates during a programme this means that the water reservoir is full. The buzzer sounds, the programme stops, the light of the Start/Pause button flashes.

“CLEAN CONDENSER” light

It comes on every 80 cycles to remind you that the condenser must be cleaned.

7