Zanussi ZDC 888 manual Something not working

Something not working

If the oven is not working correctly, please carry out the following checks, before contacting your local Zanussi Service Centre.

IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.

SYMPTOM	SOLUTION
ν The oven does not come on	υ Check the oven is in manual operation and
	that both a cooking function and temperature
	have been selected.
	υ Check the oven is wired in properly, and the
	socket switch or the switch from the mains
	supply to the oven are ON.
ν The oven temperature light does not come on	υ Select a temperature with the thermostat
	control knob
	υ Select a function with the oven function
	control knob.
ν The oven light does not come on	υ Select a function with the oven function
	control knob
	υ Check the light bulb, and replace it if
	necessary (see "Replacing the Oven Light")
ν It takes too much time to finish the dishes, or	υ The temperature may need adjusting
they are cooked too fast.
	υ Refer to the contents of this booklet,
	especially to the chapter “Using the Oven”.
ν Steam and condensation settle on the food	υ Leave dishes inside the oven no longer than
and the oven cavity.	15-20 minutes after the cooking is completed.
ν The timer does not work	υ Check the instructions for the timer.
ν The oven fan is noisy	υ Check the grease filter is correctly fitted.
	υ Check that shelves and bakeware are not
	vibrating in contact with the oven back panel.

If after all these checks, the oven still does not work, contact your local Service Force Centre.

When you contact them, they will need the following information:

1.Your name, address and post code.

2.Your telephone number

3.Clear and concise details of the fault

4.The model and the serial number (which can be found on the rating plate)

5.Date of purchase

Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls.

In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

16