Zanussi ZDF3020 manual The cleaning results are not satisfactory, Fault code and malfunction

Fault code and malfunction

•the digital display shows The dishwasher will not drain

•the digital display shows The anti-flood device operates

The programme does not start

Possible cause and solution

•There is a blockage in the sink spigot. Clean the sink spigot.

•The connection of the water drain hose is not correct. The hose can be kinked or squashed.

Make sure that the connection is correct.

•Close the water tap and contact your local Service Force Centre.

•The appliance door is not closed. Close the door.

•Mains plug is not connected in. Put in the mains.

•The fuse has blown out in the household fuse box. Replace the fuse.

•Delay start is set.

Cancel the delay start to start the programme immediately.

After the check, switch on the appliance. Set the knob on the same washing programme as before the malfunction. The programme continues from the point of interruption. If the malfunction shows again, contact your Service Force Centre.

If the display shows a fault code, not described in the chart, contact your Service Force Centre.

These data are necessary to help you quickly and cor- rectly:

•Model (Mod.)

•Product number (PNC)

•Serial number (S.N.)

For these data, refer to the rating plate.

Write the necessary data here:

Model description : ..........

Product number : ..........

Serial number : ..........

The cleaning results are not satisfactory

The dishes are not clean	• The selected washing programme is not applicable for the type of load and
		soil.
	• The baskets are loaded incorrectly so that water cannot reach all surfaces.
	• Spray arms do not turn freely because of incorrect arrangement of the load.
	•	The filters are dirty or not correctly installed.
	•	The quantity of detergent is too little or missing.
Limescales particles on the dishes	• The salt container is empty.
	• The water softener is adjusted on a wrong level.
	• The salt container cap is not closed correctly.
The dishes are wet and dull	• No rinse aid has been used.
	• The rinse aid dispenser is empty.
There are streaks, milky spots or	• Decrease the rinse aid dosage.
a bluish coating on glasses and
dishes
14