CLEANING BETWEEN THE OUTER AND INNER DOOR GLASS
To prevent damaging or weakening the door glass panels avoid the use of the following:
Household detergents and bleaches Impregnated pads unsuitable for
Brillo/Ajax pads or steel wool pads Chemical oven pads or aerosols Rust removers
Bath/Sink stain removers
Under no circumstances should the door assembly be detached from the product for cleaning. Please refer to the cleaning instructions.
The outer door glass is removable for cleaning.
TO REMOVE THE OUTER GLASS
1.Open the oven door slightly to gain access to the two cross head screws on the top of the oven door.
2.Loosen the two screws using a Pozidrive screwdriver.
3.Hold the door glass securely with one hand, before removing the screws completely with the other hand.
The screws and washers retain the trim on the top of the grill / top oven door.
Note the position of the trim on the door.
4.Using both hands, gently tilt the top of the door glass towards you. Lift slightly to disengage the locators from the two bottom brackets. The door will remain in a parked position at an angle of approximately 30°.
Grill Door Trim
5.Clean the outer and inner glass using hot soapy water or Hob Brite. DO NOT try to clean the aluminium foil which is inside the door. The foil is there to help keep the door cool, if it is damaged it will not work. Ensure that all parts are well rinsed and thoroughly dry before attempting to replace the outer door glass.
If the door glass panel becomes chipped or has deep scratches the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Please contact your local Service Centre who will be pleased to advise further.
TO REPLACE THE OUTER GLASS
1.Open the oven door with care and place in the park position at an angle of approximately 30°.
2.Holding the oven glass with both hands, gently place the locators into the holes of the brackets at the bottom of the oven door.
3.Push the top of the oven glass towards the oven door ensuring the screw location holes line up.
4.Ensure the trim is correctly positioned on the top oven / grill door.
5.Hold the glass in place at the top of the door. Insert the cross head screws into the location holes. Give the screws one turn to ensure the glass is secure.
6.Tighten the screws positively with the Pozidrive screwdriver before closing the oven door.
DO NOT attempt to use the oven without the glass being in place.
30
