Something not working
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer.
Switch off the dishwasher, open the door and carry out the following suggested corrective ac- tions.
Fault code and malfunction
•continuous flashing of the start/cancel indicator light
•1 flash of the end of programme indicator light The dishwasher does not fill with water
•continuous flashing of the start/cancel indicator light
•2 flashes of the end of programme indicator light The dishwasher will not drain
•continuous flashing of the start/cancel indicator light
•3 flashes of the end of programme indicator light
•The programme does not start
Possible cause and solution
•The water tap is blocked or furred with limescale Clean the water tap
•The water tap is turned off
Turn the water tap on
•The filter (where present) in the threaded hose fitting at the water inlet valve is blocked
Clean the filter in the threaded hose
•The water inlet hose has not been correctly laid or it is bent or squashed
Check the water drain hose connection
•The sink spigot is blocked Clean out the sink spigot
•The water drain hose has not been correctly laid or it is bent or squashed
Check the water drain hose connection
•
Close the water tap and contact your local Service Force Center.
•The dishwasher’s door has not been properly closed
Close the door
•The main plug is not plugged in Insert the main plug
•The fuse has blown out in the household fuse box Replace the fuse
•Delay start has been set
If dishes are to be washed immediately, cancel the delay start
18
