TO FIT THE MAIN OVEN SHELVES
The shelves should be fitted with the straight rods uppermost on the frame and the forms towards the back of the oven.
To remove a shelf slide the shelf towards you until the shelf stop is reached. Tilt shelf up at the front so that the stops clear the side supports. Lift shelf clear. To install a shelf, reverse the above steps. Each shelf position has an upper and lower support wire, ensure the shelf is placed between these two support wires.
USING THE TELESCOPIC RUNNERS
(where fitted)
1.Ensure the telescopic runners are pushed back into the oven cavity before fitting the shelf.
2.Holding the front edge of the shelf with both hands, place the rear shelf forms over the telescopic runners.
3.Slide the shelf into position, lifting slightly at the front so that the shelf locates into the retaining hooks.
To remove, raise the front edge and withdraw the shelf.
Ensure the shelf is positively located before using.
Note:
Should you wish to purchase a telescopic runner kit, this can be ordered from your local Service Force Centre by quoting part number (BAZ D02).
HINTS AND TIPS
•Arrange the shelves in the required positions before switching the oven ON. Shelf positions are counted from the bottom upwards.
•When cooking more than one dish in the fan oven, place dishes centrally on different shelves rather than cluster several dishes on one shelf, this will allow the heat to circulate freely for the best cooking results.
•When batch baking one type of food, e.g. Victoria sandwich cakes, those of similar size will be cooked in the same time.
•It is recommended that when baking larger quantities the shelf positions should be evenly spaced to suit the load being cooked. A slight increase in cooking time may be necessary.
•Do not place baking trays directly on the oven base as it interferes with the oven air circulation and can lead to base burning; use the lower shelf position.
Do not place cookware and cooking pots with rough bases e.g. cast iron on the oven door as damage to the glass may occur.
RETAINING HOOK
FORM
22
