Zanussi ZERB 8643 manual Problem, Possible cause, Solution

	Problem				Possible cause	Solution
It is too warm in the					Thermostatic control can be set wrongly.	Set the thermostat knob to higher
refrigerator.						position.
					If products are not cold enough or	Place the products to the appropriate
					placed wrongly.	place.
					The door does not close tightly or it is not	Check if the door closes well and the
					shut properly.	gasket is unhurt and clean.
It is too warm in the					Thermostatic control can be set wrongly.	Set the thermostat knob to higher
freezer.						position.
					The door does not close tightly or it is not	Check if the door closes well and the
					shut properly.	gasket is unhurt and clean.
					Products in big quantity to be frozen	Wait some hours and then check the
					were put in.	temperature again.
					Products to be frozen are placed too	Place the products in a way so that
					closely to each other.	cold air could circulate among them.
Water flows at the back					It is normal. During automatic defrosting
plate of the refrigerator.					frost melts on the back plate.
Water	flows		into	the	The outlet of the chamber can be	Clean the outlet.
chamber.					clogged up.
					Products placed in can prevent water	Replace the products so that they can
					from flowing into the collector.	not touch the back plate directly.
Water	flows		onto	the	The melting water outlet flows not into	Put the melting water outlet to the
floor.					the evaporative tray above the	evaporative tray.
					compressor.
There are too much frost					Products are not wrapped properly.	Wrap the products better.
and ice.					Doors are not shut properly or do not	Check if the doors close well and the
					close tightly.	gaskets are undamaged and clean.
					The thermostatic control can be set	Set the thermostat knob to a position
					wrongly.	that gives higher temperature.
The		compressor			The thermostatic control is set wrongly.	Set the thermostat knob to a position
operates continually.						that gives higher temperature.
					Doors are not shut properly or do not	Check if the doors close well and the
					close tightly.	gaskets are unhurt and clean.
					Products in big quantity to be frozen	Wait some hours and then check the
					were put in.	temperature again.
					Too warm food was put in.	Put food at max. room temperature.
					The appliance is in too warm place.	Try to reduce the temperature in the
						room where the appliance stands.
The appliance does not					Plug is not connected to the mains	Connect the mains plug properly.
work	at	all.	Neither		socket properly.
cooling,		nor	lighting		The fuse burnt out.	Change the fuse.
works.
					The thermostatic control is not on.	Start the appliance according to
						instructions in chapter 'Putting it into
						use'.
					There is no voltage in the mains socket.	Call an electrician.
					(Try to connect another appliance into it.)
The appliance is noisy.					The appliance is not supported properly.	Check if the appliance stands stable
						(all the four feet should be on the
						floor).

Inasmuch as the advice does not lead to result, call the nearest brand-mark service.

12