gradually removing it from the cabinet, slightly tilting both doors. Do not forget to remove the plastic spacer (b) under the hinge. (fig.2)
5.Take off the refrigerator door by pulling it slightly downwards.
6.Take of the freezer door by pulling it slightly upwards.
7.Remove the plug on the upper side of the refrigerator door and put it to the other side.
8.Remove the plug on the upper side of the freezer door and put it to the other side.
9.Unscrew the top door hinge pin (d) of the refrigerator then screw it back on the other side. (fig.1)
10.Remove the plugs (u) at the bottom of the appliance. (fig. 3)
11.Remove the lower hinge (e) by removing its screws
(s) and mount it on the other side. (fig.3)
12.Unmount the lower hinge pin (f) and its washer (h) and mount them into the other hole of the lower hinge. (fig.3)
13.Replace the plugs (u) on the other side.
14.Remove the covering pins (3 pieces) (n, k) of the double door holder on the left side and put them to the other side. (fig.2)
15.Fit the pin of the double door hinge (m) into the left hole of the freezer door. (fig.2)
16.Fit the freezer door to the lower door hinge pin (f). (fig.3)
17.Fit the refrigerator door to the upper door hinge pin (d) then slightly tilting both doors fit the pin of the double door hinge (m) into the left hole of the refrigerator door.
18.Opening both doors fix the double door hinge onto the left side using the screws (2 pieces) (c). Do not forget to replace the plastic spacer (b) under the hinge. Be careful that the door edges are parallel with the edge of the mantle.
19.Put over the handles (r) on the other side and put the plastic covering pins (p) supplied in the plastic bag of this instruction book into the vacant holes. (fig.4)
20.Put the appliance to its place, ensure it is level, and plug it into the mains supply.
In case you do not want to perform the procedures above, call the nearest Service Force Centre.
Technicians will make a charge for door reversal.
Important
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating the part involved with a normal hairdryer on a low setting.
fig. 2.
fig. 3.
fig. 4.
17
