When the ice melts, the water flows through the defrost water outlet through the back into the evaporator tray which sits on the top of the compressor and evaporates due to its warmth.
Check and clean the defrost water outlet regularly - a label inside the appliance warns you for this. If it is blocked the water gathered can cause damage to the insulation of
the appliance.
Clean the defrost water outlet with the supplied pipe scraper that can be seen in the figure. The pipe scraper has to be stored in the outlet.
Extra care should be taken when putting wrapped foods, especially in paper, in the appliance. Blockages to the defrost water outlet often occurs when wrapped foods are placed in the back of the refrigerator, and the wrapping contacts the back plate of the fridge and sticks to it.
In case of increased demand e. g. during heatwawes, the refrigerator temporarily happens to operate constantly - during this the automatic
defrosting does not work.
Remaining small ice and frost stains on back plate of the refrigerator after the defrosting period is normal.
Defrosting of the freezer is automatic in this model.
Important
A temperature rise of the frozen food packs during defrosting may shorten their safe storage life. Never use sharp metal tools to scrape off frost from the evaporator as this could damage the appliance beyond repair.
)To Change the Light Bulb
Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Unscrew the screw holding the cover (1), press the rear hook (2) and at the same time slide the cover in the direction indicated by arrow (3). So the bulb can be replaced. (Bulb type:
After changing the bulb replace the cover, snap it in place, screw back the screw and apply voltage to the appliance
13
