Installation
Caution! Read the "Safety Information" carefully for your safety and correct operation of the
appliance before installing the appliance.
Positioning
Install this appliance at a location where the ambient tem- perature corresponds to the climate class indicated on the rating plate of the appliance:
Climate | Ambient temperature |
class |
|
SN | +10°C to + 32°C |
N | +16°C to + 32°C |
ST | +16°C to + 38°C |
T | +16°C to + 43°C |
Location
The appliance should be installed well away from sour- ces of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appli- ance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm . Ideally, howev- er, the appliance should not be positioned below over- hanging wall units. Accurate levelling is ensured by one or more adjustable feet at the base of the cabinet.
Warning! It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
min.100 mm |
|
A | B |
20 mm |
|
Electrical Connection
Caution! Any electrical work required to install this appliance should be carried out by a qualified
electrician or competent person.
Warning! This appliance must be earthed. The manufacturer declines any liability should
these safety measures not be observed.
12
3
4
5
Important! The wires in the mains lead are coloured in accordance with the following code:
| Green and Yellow: | Earth |
1 | ||
| Brown: | Live |
3 | ||
| Blue: | Neutral |
5 |
As the colours of the wires in the mains lead of this ap- pliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
1.Connect the wire coloured green and yellow to the terminal marked either with the letter “E“ or by the earth symbol 
or coloured green and yellow.
2.Connect the wire coloured blue to the terminal ei- ther marked with the letter “N“ or coloured black.
3.Connect the wire coloured brown to the terminal ei- ther marked with the “L“ or coloured red.
4.Check that no cut, or stray strands of wire is present and the cord clamp 4 is secure over the outer sheath.
5.Make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.
6.Switch on the appliance.
7
