Zanussi ZRB 8441 W manual Removal of glass shelf blockers from the product, Door reversal

Models: ZRB 8441 W

1 24
Download 24 pages 26.49 Kb
Page 18
Image 18
Removal of glass shelf blockers from the product

Removal of glass shelf blockers from the product

The glass shelf blockers are used to fix the shelves into position during product transport. These blockers will not be necessary for the further operation of the product.

Open the refrigerator door as wide as possible.

1 Slide the blocker tabs to the front of the shelf.

2 Lift the back of the shelf from its nest and then pull

it towards yourself by tilting its front upwards/downwards.

3 Remove the blocker tabs.

Door reversal

Should the location demand it, the door-opening direction can be refitted from right-handed to left-handed.

Appliances are supplied right-handed.

Following operations are to be done on the basis of figures and explanations:

To perform the operations listed below it is recommended to ask another person for help who safely can hold the doors while performing the operations.

Disconnect the appliance from the electricity supply.

Open the doors and dismount the double door hinge (a, b) by removing the screws (2 pieces) (c). (fig.2)

Take off the double door hinge (a, b, c) by gradually removing it from the cabinet, slightly tilting both doors. Do not forget to remove the plastic spacer (b) under the hinge. (fig.2)

Take off the refrigerator door by pulling it slightly downwards.

Take of the freezer door by pulling it slightly upwards.

Remove the plug on the upper side of the refrigerator door and put it to the other side.

Remove the plug on the upper side of the freezer door and put it to the other side.

Unscrew the top door hinge pin (d) of the refrigerator then screw it back on the other side. (fig.1)

Remove the plugs (u) at the bottom of the appliance. (fig.3)

Remove the lower hinge (e) by removing its screws (s) and mount it on the other side. (fig.3)

Unmount the lower hinge pin (f) and its washer (h) and mount them into the other hole of the lower hinge. (fig.3)

Replace the plugs (u) on the other side.

Remove the covering pins (3 pieces) (n, k) of the double door holder on the left side and put them to the other side. (fig.2)

Fit the pin of the double door hinge (m) into the left drill hole of the freezer door. (fig.2)

Fit the freezer door to the lower door hinge pin (f). (fig.3)

fig. 1.

fig. 2.

18

Page 18
Image 18
Zanussi ZRB 8441 W manual Removal of glass shelf blockers from the product, Door reversal, Remove the blocker tabs