Spray arm (1)
It is important to keep all the holes in the spray arm clear. A clogged hole can seriously affect washing efficiency.
If the spray arm needs cleaning, unscrew the nut anti- clockwise, remove the washer and lift off the spray arm. Clear the holes and shake out any food remnants.
Coarse strainer/microfilter (2)
The purpose of the coarse strainer is to catch large objects such as a cocktail stick and pieces of eggshell. Make sure that the strainer is always clean. Turn the coarse strainer
Fine filter (3)
It is just as important to keep this filter clean. A dirty or clogged filter will always impair washing efficiency. The fine filter can easily be lifted out for cleaning when you have removed the coarse strainer.
Detergent dispenser (4)
Open the lid to the dispenser by pressing the lid catch towards the compartment. Consult the instructions on the detergent packet, fill the compartment accordingly and close the lid. Remember that the instructions usually refer to
Only use detergents specially designed for dishwashers.
Rinse aid dispenser (5)
Use of rinse aid will result in cleaner and faster drying of the load, since it helps water and residues to run off. Too much rinse aid may result in streakiness, too little may cause white spots. The dispenser holds about 150 ml. This is enough for approx. 60 wash cycles, depending on the dosage setting. Adjust the dosage setting according to the hardness of the water.
You can set the dosage between 1 - 6, the appli- ance is factory set to 1.
Begin at the lowest dosage setting and increase if necessary by turning the setting arrow with e.g. the handle of a spoon.
The amount of rinse aid can be checked trough the lens on the dispenser. When the lens is clear, requires refilling of rinse aid.
1. Open the lid to the dispenser by pressing the lid catch towards the compartment and lift the lid.
2. Fill up with rinse aid; do not overfill.
3.Wipe off any spillage carefully to prevent excessive foaming during the next wash programme.
4.Close the lid and press until it locks again.
Do not fill the rinse aid dispenser with liquid detergent.
Zanussi recommends the use of Finish dish- washer detergent and Rinse Aid.
Water softener (6)
This dishwasher is equipped with a water softener for hard water. The lime in hard water causes white deposits to occur on dishes and to the interior of the dishwasher. To prevent this, the water has to pass through a special container where the hardness is removed.
Since the water softener uses dishwasher salt, you will have to refill the salt container after a certain number of dishwasher cycles.
It is extremely important, that the salt container is filled up with the dishwasher salt before using the dishwasher for the first time.
The 
indicator light on the control panel is lit when the container requires refilling.
1. Unscrew the filler cap to the salt container anti- clockwise.
2.Fill the salt container with water (only the first time).
3.Fill the container with dishwasher salt, using the funnel supplied.
4.Remove the funnel and wipe off any spillage around the filler opening.
5.Screw the filler cap back properly in place.
The water softener is now ready for the first load of dishes. Always make sure that there is dishwasher salt in the container, which holds about 1 litre.
How to adjust the water softener, see chapter ”Adjusting the water softener”.
Only use special salt for dishwashing machines, ordinary domestic salt, especially table salt, can damage the water softener.
- 5 -
