Using the appliance
Starting the programme
1. Scrape or rinse off solid food remnants.
2.Load the dishwasher.
(See the basket and loading).
3.Put the correct amount of detergent into the detergent dispenser and close the dispenser lid.
4.Close the door.
5.Select the required programme (see programme chart). The programme indicator lamps starts to flash.
6.Press in the start button. The lamp for the start button comes on and dishwashing cycle starts. The programme indicator lamps always indicates which part of the selected cycle the dishwasher is in.
7.Check the filters to see if they need to be cleaned when the dishwasher has finished the programme.
Interrupting the programme temporarily
1. Open the door. The programme stops.
2.Close the door and the programme continues after about six seconds.
Open the door carefully when the dishwasher is running, since hot steam may escape.
Cancelling the programme
1. Press and hold in the start button until the programme indicator lamps goes out.
2.Release the button, the programme indicator lamps starts to flash.
3.Turn the programme selector to the ”Reset” position. The programme is now cancelled and a new programme can be selected.
If you simply turn the programme selector to the ”Reset” position, the selected programme is not finished, it is only disrupted. The programme will continue if you turn the programme selector to the programme again.
Cancelling the drying phase
In case you do not want to wait until the drying phase is completed, you can cancel it.
1. Press and hold in the start button until the programme indicator lamps starts to flash, then release the button.
2. Open the door. The drying phase is cancelled.
Switching the dishwasher off
Switch the dishwasher off, when the indicator lamp for the programme cycle end is lit.
1. Turn the programme selector to the ”Reset” position. All indicator lamps goes out.
Leave the door slightly ajar.
Be careful if you open the door immediately after the programme is finished, since hot steam may escape.
- 10 -
