Zanussi ZSS 7/5 X, ZSS 7/5 W manual Technical Specifications, Installation, Positioning

Models: ZSS 7/5 X ZSS 7/5 W

1 16
Download 16 pages 50.58 Kb
Page 13
Image 13
Technical Specifications

Technical Specifications

DIMENSIONS

Height

85

cm

 

Width

89.5

cm

 

Depth

60

cm

POWER SUPPLY VOLTAGE AND FREQUENCY

220-240 V / 50 Hz

 

TOTAL POWER ABSORBED

110 W

 

 

AVERAGE DAILY UNITS ELECTRICITY(*)

0.98 kWh

 

GROSS CAPACITY

Fridge

130 l

 

 

Freezer

83 l

 

NET CAPACITY

Fridge

128 l

 

 

Freezer

52 l

 

STAR RATING

(*)This figure is based on standard test results in accordance with the European Standard EN153. Actual consumption will depend on how the appliance is used and where it is located.

Installation

Positioning

For this appliance to work efficiently, it must not be located where the temperatures will fall below 10¡C (50¡F) or rise above 32¡C (90¡F), e.g. conservatories.

For correct operation this appliance must be located in a dry atmosphere, away from heat sources, e.g. cookers, radiators, boilers and direct sunlight.

You should also ensure that air can circulate freely around the back and the top of the cabinet. There should be 100mm (4Ó) between the top of the cabinet and any overhanging kitchen furniture. Alternatively allow 50mm (2Ó) between the top of the cabinet and any overhanging kitchen furniture and a gap of 25mm (1Ó) on either side of the appliance.

It is important that the bottom grill is not obstructed as the air must circulate freely through this grill.

-50 mm100

A

mm10 InstallationPositioningManual background NP006

B mm10 Manual backgroundManual backgroundManual background

Adjust the level of the appliance by screwing out the adjustable foot, or feet, at the bottom of the cabinet using your fingers.

Do not obstruct the space underneath. The back of the cabinet may be placed close to the wall but must not touch it. DO NOT install in places with restricted ventilation.

13

Page 13
Image 13
Zanussi ZSS 7/5 X, ZSS 7/5 W manual Technical Specifications, Installation, Positioning