Zanussi ZT 51 RL manual Electrical Connection, Green and Yellow, Earth, Blue, Neutral, Brown, Live

Models: ZT 51 RL

1 16
Download 16 pages 38.81 Kb
Page 14
Image 14
ELECTRICAL CONNECTION

ELECTRICAL CONNECTION

WARNING:

THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed.

If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted.

Remove the fuse from the cut off plug.

The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13amp socket in another part of your home.

Important

The wires in the mains lead are coloured in accordance with the following code:

Green and Yellow

- Earth

Blue

- Neutral

Brown

- Live

If you fit your own plug, the colours of the wires in the mains lead of your appliance, may not correspond with the markings identifying the terminals in your plug, proceed as follows:

Connect the Green and the Yellow (earth) wire to the terminal in the plug which is marked with the letter

«E» or the earth symbol Green and Yellow , or coloured green and yellow.

Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter «N» or coloured black.

This appliance complies with the E.E.C. Directive No. 87/308 of 2.6.87 relative to radio interference suppression.

This appliance complies with the following E.E.C. Directive:

-73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent amendments.

-89/336 EEC of 3.5.89 (Electromagnetic

-Compatibility Directive) and subsequent amend- ments.

Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of breakdown.

GREEN & YELLOW

13 AMP. FUSE

13 AMP

BROWN

BLUE

Connect the brown (live) wire to the terminal in the plug which is marked with the letter «L» or coloured red.

The plug moulded onto the lead incorporates a fuse. For replacement, use a 13amp BS1362 fuse. Only ASTA or BSI approved fuses should be used.

The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug.

A replacement cover/carrier must be obtained from your local Zanussi Service Force Centre whose address is listed in the Customer Care Booklet which accompanies your instruction manual.

D207

CORD CLAMP

14

Page 14
Image 14
Zanussi ZT 51 RL manual Electrical Connection, Green and Yellow, Earth, Blue, Neutral, Brown, Live