Zanussi ZT 685 Operating sequence, Check the filters, Start the programme, Select the programme

Models: ZT 685

1 32
Download 32 pages 20.4 Kb
Page 16
Image 16
Operating sequence

Operating sequence

1. Check the filters

Ensure they are clean and properly positioned (see cleaning instructions).

2.Check that there is rinse aid and salt

3.Load the dishes

Remove any scraps of food.

Pull the lower basket out and arrange the saucepans, plates and cutlery in it.

Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.

Slide the basket back into the machine.

4.Ensure that the spray arms can rotate freely.

5.Measure out detergent

Add the required amount of detergent into the dispenser according to the "Washing programmes" chart and close the lid.

6.Close the detergent dispenser lid

7.Select the programme

The selection of a programme occurs with the door partially opened.

Depress the On/Off button; the On/Off indicator light comes on.

Depress the programme button which corresponds to the washing programme you wish to select; the corresponding indicator light will flash.

8. Start the programme

Close the dishwasher door. An audible signal of about 1 second advises you that the programme has started. The indicator light which corresponds to the programme under way is now permanently on.

9. At the end of the washing programme

The dishwasher will automatically stop and an intermittent audible signal of about 5 seconds informs you that the programme has finished.

Wait until the end of the signal before opening the door.

10. Switch off the dishwasher

Open the door.

The "End of cycle" indicator light flashes.

Depress the On/Off button to switch the dishwasher off.

11. Cancel the wash programme

To change a wash programme in progress depress the button corresponding to the programme you wish to cancel for about 1 second, until the relevant control light goes out.

The dishwasher is now reset and you can select a new programme.

1. Check the filters In general it is not advisable to open the door while the machine is working. If the door is opened however, a safety device ensures that the machine stops.

Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape.

When the wash programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off.

16

POS06UK

Page 16
Image 16
Zanussi ZT 685 manual Operating sequence, Check the filters, Check that there is rinse aid and salt 3. Load the dishes