Door reversibility
Remove the two screws which fix the upper hinge to the door.
Carefully lean the appliance on its back and remove the plastic insert.
Remove the two screws which fix the lower hinge to the door.
Remove the four screws which fix the lower hinge to the base of the appliance and remove the hinge itself; be very careful to recover all the screws.
Remove the four screws that fix the upper hinge to the appliance and remove the hinge itself.
Take the hinge removed from the upper part of the appliance on the opposite side, and, using the screws removed from the lower part, fix it to the base of the appliance itself.
Remove and refit the other hinge on the upper part of the appliance on the opposite side.
Fix the two front screws into the upper and lower hinges.
Finally, check the alignment of the door and make sure it closes properly.
After having reversed the opening direction of the door, discard the original plastic insert removed and fit the insert supplied with the appliance on the opposite side.
Fitting a decorative door panel
Import ant: The components needed to fit the decorative panel have been
The brackets are secured to the panel by means of the 7 ¯ 3.5x13 screws supplied. Before starting to fit the panel, remove the large top bracket by unscrewing the screws and adjusting pins
The small bottom bracket need not be removed.
Place the appliance in the position where it is to be built in.
The appliance is fitted with adjustable feet; screw the front and rear feet in or out to adjust the height of the appliance to that of the recess. Keeping the appliance central in the recess, slide it in until its back touches the wall.
Wõth a tape measure (or similar instrument), measure distance (A) between the top edge of the door and the top edge of the decorative panel, placing it next to the recess.
D447 |
D510 |
| A |
= | = |
D467 |
|
16
