OPERATION
Before using
Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water).
Do not use soap or detergent as the smell may linger. Dry thoroughly.
Control panel
6 | 1 | |
5 | ||
2 | ||
4 | ||
3 |
A - Thermostat control
B - Pilot light
To Start the Appliance
Allow the appliance to stand for 2 hours after installation.
Plug in the appliance and switch on at the mains supply. Turn the thermostat control (A) to a midway setting
(B)will illuminate. Leave the appliance for approximately 4 hours for the correct temperature to be reached before placing food inside.
To switch off the appliance turn the thermostat control to position Ò●Ó
Setting the temperature
The temperature inside the appliance is regulated by a thermostat with 6 temperature positions and an ÒOFFÓ (●) position.
Position 1 = minimum coldness Position 6 = maximum coldness
Turn the thermostat dial to the required position.
The intermediate position is usually the most suitable
The thermostat control regulates the temperature both within the fridge and the freezer compartment. The thermostat setting can vary as the temperature inside the appliance depends on the following factors:
Ðroom temperature
Ðhow often the door is opened
Ðhow much food is stored
Ðposition of the appliance
AB
Use of an air circulation slider control - COOL FLOW SYSTEM
Your appliance has an air circulation slider control situated at the rear of the fridge compartment, which controls the amount of cold air circulated through the fridge compartment.
When the ambient temperature is between 10¡C and 16¡C, the slider control should be in the ÒcoldÓ position.
When the ambient temperature is above 16¡C the slider control should be midway between ÒcoldÓ and ÒcoldestÓ.
When the ambient temperature is very high (i.e. hot summer days) position the slider control to ÒcoldestÓ.
COLD | COLDEST |
|
COOL FLOW SYSTEM |
| |
| COLD | COLDEST |
| COOL FLOW SYSTEM | |
D757 |
|
|
5
