Removing and Replacing Cameo 3 Battery Packs
To remove the battery pack from the Cameo 3:
Slide the Battery Latch button in the direction shown in the top illustration below, and slide the battery out.
To replace the battery, insert the end with the contacts into the battery well and slide the battery into the printer until in clicks into place .
Battery Latch
Button
Battery Pack
REMOVING AND REPLACING CAMEO 3
BATTERY PACKS
Low Battery Shutdown
As the battery charge level in becomes depleted the Power LED will flash. At this time the printer should be shut off and the battery pack recharged or replaced.
Cameos will automatically shut off if the batteries become severely discharged.
Safety Warnings
Use of a charger not approved by Zebra for use with Cameo series NiMH batteries could damage the battery pack or the printer and will void the warranty.
Battery terminals are recessed to prevent short circuiting of the battery. Allowing these terminals to contact conductive material will create a short circuit which could cause burns, other injuries or start a fire.