INSTALLATION OF MEDIA
The following details media installation:
Cameo 2 is illustrated. Loading procedure is identical for all units.
1.Turn unit off.
2.Squeeze the two finger grips on either side of the media compartment cover. Rotate the top back to reveal the paper compartment.
3.If necessary, adjust the edge guide as shown at left for narrow media.
The edge guide should be set into the nearest slot in the printer body that will allow the media roll to spin freely yet prevent it from wandering from side to side so much that print quality is affected.
4.Drop a new roll of paper into the compartment. Media should feed from the top of the roll and the roll should fit between the edge guide and the right
hand wall.
The inner core on the media roll should be Ø.75” [ 19 mm] or larger to prevent the roll from jamming.
5.Close the cover while holding the free end of the media roll.
6.Insure the cover is securely latched before begin- ning to print.