BATTERIES AND CHARGING

Conditioning Battery Packs

Cameo batteries must be cycled several times before maximum capacity is realized.

A battery is ”cycled” by fully charging it, then fully discharging it through normal use.

Chargers

Listed below are the specifications for the Cameo series chargers:

UCN72-4: ( p/n series AC15482-tab)

Designed to charge up to four batteries simulta- neously. Battery packs may be charged separately or while plugged into the printer. Typical charge time is 90 minutes. Switch selectable 110/220 V.A.C. input voltage. Supplied with line cords compatible with most international standards.

Do not attempt to charge batteries with the UC72-4 Charger while printing. Attempting to print while charging batteries can result in unreliable charging.

UCN72-4 part numbers vary depending on specific country of use. Consult factory for complete part numbers.

UCN72: ( p/n series AT15244-tab)

A wall mounted single charger with universal 110 to 230, 50-60 Hz. VAC input. Multiple plug configurations comply with most international standards.

Do not attempt to charge batteries with the UC72N Charger while printing. Attempting to print while charging batteries can result in unreliable charging.

UC72N part numbers vary depending on specific country of use. Consult factory for complete part numbers.

O-3

UMAN-CM2/3