Programming Brand Codes, TV Code, Cable Code

PROGRAMMING BRAND CODES

Introduction		1. Press MODE repeatedly to select the desired TV,
Before using your new remote control, it must be programmed		VCR or CABLE operating mode for the remote.
		2. Press LEARN for about 5 seconds until the MODE
to recognize the brands of equipment it will be used to
operate. If you are using a Zenith VHS VCR or a Zenith		indicator lights for the selected TV, VCR or CABLE
cable-TV decoder, the remote has already been programmed		mode of operation.
for you.		3. Enter the proper brand code number for the equipment
Find the code that corresponds to each brand and type of		to be controlled.
equipment you are going to operate. Refer to Tables 1,2 and 3.		4. Press LEARN. All three mode indicators should light
For example, if you were programming the remote for use		briefly, then turn off to indicate the brand code has
with a Zenith TV, you would look for “Zenith” in “Table I”,		been programmed.
and find code “101.”		5. If all three mode indicators fail to light briefly, an
Write the brand codes for your equipment on the following		error has occurred. Repeat Steps 1-4 to try again.
lines.		6. Repeat steps 1-4 to	program the remote for the other
TV CODE:		equipment you are	using.
CABLE CODE:	-	NOTE: CABLE mode can be programmed to operate a
		second TV or second VCR, if desired.
VCR CODE:
		When batteries are removed: It will be necessary to reprogram
		the proper VCR and cable-TV decoder codes.

Operating MODE Selector

Operating Mode

Indicators

Numbered Buttons

Use to enter code number for desired brand.

LEARN Button

~c3~~

SWAP TIMER SEQ

CCDCIDCD

RECORD STOP PAUSE SEARCH

a3cEB~cz3

REW PLAY F FWD TVNCR

2 7 3 6 - O

4 - 6