Zenith XBR716 warranty Lock Parental Control Settings, Rating, Set Password, Area Code

Lock (Parental Control) Settings

Rating

Blocks playback of rated DVDs based on their content. Not all discs are rated.

1. Select [Rating] option then press B.

2.To access the Rating, Password and Area Code features, you must input the 4-digit security code you created.

If you have not yet entered a security code you are prompted to do so. Input a 4-digit code. Enter it again to verify. If you make a mistake press

CLEAR.

3.Select a rating from 1 to 8 using the v / V buttons.

[1]-[8]: Rating one (1) has the most restrictions and rating eight (8) is the least restrictive.

[No Limit]: If you select [No Limit], parental control is not active and the disc plays in full.

4.Press ENTER to confirm your rating selection, then press HOME to exit the menu.

5.Press EJECT, OPEN/CLOSE (Z) to activate parental control.

Note:

If you set a rating for the recorder, all disc scenes with the same rating or lower are played. Higher rated scenes are not played unless an alternate scene is available on the disc. The alternative must have the same rating or a lower one. If no suitable alternative is found, playback stops. You must enter the 4-digit password or change the rating level in order to play the disc.

Set Password

You can enter or change password.

1.Select [Set Password] option then press B.

2.Follow step 2 as shown [Rating].

To change the password, press ENTER when the [Change] option is highlighted, then input old password. Input new password.

Enter it again to verify.

To delete the password, select [Delete] option then press ENTER, then input old password. The password is deleted.

3.Press HOME to exit the menu.

If you forget your password

If you forget your password you can clear it using the following steps:

1.Press HOME and the Home menu appears.

2.Select [Setup] > [Start] and press ENTER.

3.Input the 6-digit number [210499]. The message appears, select [OK] then press ENTER. The security code is cleared.

4.Enter a new code as described above.

Area Code

Enter the Area Code whose standards were used to rate the DVD video disc, based on the list in the reference chapter (see page 44).

1.Select [Area Code] option then press B.

2.Follow step 2 as shown [Rating].

3.Select the first character using v / V buttons.

4.Shift the cursor using B buttons and select the second character using v / V buttons.

5.Press ENTER to confirm your area code selection, then press HOME to exit the menu.

18