BC2604DL / BC2604DW
8. Operation
STARTING ENGINE
WARNING
The cutting head will start rotating upon the engine starts.
1.Feed fuel into the fuel tank and tighten the cap se- curely.
2.Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects, as it will start rotating upon starting of the engine.
3.Push the primer pump several times until overflown fuel flows out in the clear tube.
(1)choke lever
(2)close
(3)open
(4)primer pump
4.Move the choke lever to the closed position.
5.Set the ignition switch to the “I” position. Set the throttle
lever to the start position (1 → 2 → 3). Place the unit on a flat, firm place.
Keep the cutting head clear of everything around it.
START
O : Stop
I : Start
3. Ignition switch
BC2604DLBC2604DW
WARNING
The product is equipped with a centrifugal clutch mecha- nism, so the cutting attachment begins to rotate as soon as the engine is started by putting the throttle into the start position. When starting the engine, place the product onto the ground in a flat clear area and hold it firmly in place so as to ensure that neither the cutting part nor the throttle come into contact with any obstacle when the en- gine starts.
IMPORTANT
•Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.
7.Move the choke lever downward to open the choke. And restart engine.
8.Allow the engine to warm up for a several minutes before starting operation.
NOTE
1.When restarting the engine immediately after stopping it, leave the choke open.
2.Overchoking can make the engine hard to start due to ex- cess fuel. When the engine failed to start after several at- tempts, open the choke and repeat pulling the rope, or re- move the spark plug and dry it.
STOPPING ENGINE
6.While holding the unit firmly, pull out the starter rope quickly until engine fires.
START
O : Stop
I : Start
3. Ignition switch
BC2604DLBC2604DW
1.Release the throttle lever and run the engine for half a minute.
2.Shift the ignition switch to the STOP position.
IMPORTANT
•Except for an emergency, avoid stopping the engine while pulling the throttle lever.
