Zenoah BCZ3200DL owner manual Before Starting Engine, Starting the Engine, Using the Product

BCZ3200DL / BCZ3200DW

5. For safe operation

BEFORE STARTING

THE ENGINE

1. The area within a perimeter of

15 m (50 ft) of the person using the product should be considered a hazardous area into which no one should enter. If necessary, yellow warning rope, warning signs should be placed around the perimeter of the area. When work is to be performed simultaneously by two or more persons, care should also be taken to constantly look around or otherwise check for the presence and locations of other people working so as to maintain a distance between each person sufficient to ensure safety.

2.Check the condition of working area to avoid any accident by hitting hid- den obstacles such as stumps, stones, cans, or broken glass.

IMPORTANT

Remove any obstacle before begin- ning work.

3.Inspect the entire unit for loose fas- teners and fuel leakage. Make sure that the cutting attachment is prop- erly installed and securely fastened.

4.Be sure to attach the cutting at-

tachment guard securely in place, or you may get serious injury.

5. Always use the shoulder strap. Adjust the strap for comfort be- fore starting the engine. The strap should be adjusted so the left hand can comfortably hold the handlebar grip approximately waist high.

STARTING THE ENGINE

1. Keep bystanders and animals at least 15 m (50 ft) away from the op- erating point. If you are approached, immediately stop the engine.

2. The product is equipped with a centrifugal clutch mechanism, so the cutting attachment begins to rotate as soon as the engine is started by putting the throttle into the start position. When starting the

WARNING

Never place the throttle into the high-speed position when starting the engine.

3.After starting the engine, check to make sure that the cutting at- tachment stops rotating when the throttle is moved fully back to its original position. If it continues to rotate even after the throttle has been moved fully back, turn off the engine and take the unit to your authorized ZENOAH servic- ing dealer for repair.

USING THE PRODUCT

IMPORTANT

Cut only materials recommended by the manufacturer. And use only for tasks explained in the manual.

1.	Grip the handles firmly with both
	hands using your whole hand.
	Place your feet slightly apart
	(slightly further apart than the
	width of your shoulders) so that
	your weight is distributed evenly
	across both legs, and always be
	sure to maintain a steady, even
	posture while working.
2.	Keep cutting attachment below
	waist level.
3.	Maintain the speed of the engine
	at the level required to perform
	cutting work, and never raise the
	speed of the engine above the
	level necessary.
4.	If the unit starts to shake or vi-
	brate, turn off the engine and
	check the whole unit. Do not use
	it until the trouble has been prop-
	erly corrected.
5.	Keep all parts of your body away
	from rotating cutting attachment
	and hot surfaces.
6.	Never touch the muffler, spark
	plug, or other metallic parts of the
	engine while the engine is in op
	eration or immediately after shut-
	ting down the engine. Doing so

GB-6

engine, place the product onto the ground in a flat clear area and hold it firmly in place so as to ensure that neither the cutting part nor the throttle come into contact with any obstacle when the engine starts.

could result in serious burns or

electrical shock.