Zenoah BCZ3200DW owner manual Operation, Starting Engine, choke lever, close, 3 3 open, BCZ3200DL

BCZ3200DL / BCZ3200DW

8. Operation

STARTING ENGINE

WARNING

The cutting head will start rotating upon the engine starts.

1.Feed fuel into the fuel tank and tighten the cap se- curely.

2.Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects, as it will start rotating upon starting of the engine.

3.Push the primer several times until overflown fuel flows out in the clear tube.

4. Move the choke lever to the closed position.

	(1)
	(2)	(1) choke lever
		(2) close
	(3) (3) open
[BCZ3200DL]		[BCZ3200DW]
(3)	1	(3)
START
2	(3) Stop switch

5. [BCZ3200DL] Set the stop switch to the “I” posi- tion. Set the throttle trigger to the start position (1 → 2

→3).

Place the unit on a flat, firm place.

Keep the cutting head clear of everything around it. [BCZ3200DW] Set the stop switch to the “RUN” po- sition. Place the unit on a flat, firm place. Keep the cutting head clear of everything around it.

6. While holding the unit firmly, pull out the starter rope quickly until engine fires.

WARNING

The product is equipped with a centrifugal clutch mechanism, so the cutting attachment begins to ro- tate as soon as the engine is started by putting the throttle trigger into the start position. When starting the engine, place the product onto the ground in a flat clear area and hold it firmly in place so as to en- sure that neither the cutting part nor the throttle trig- ger come into contact with any obstacle when the engine starts.

IMPORTANT

•Avoid pulling the rope to its end or returning it by re- leasing the knob. Such actions can cause starter fail- ures.

7.Move the choke lever downward to open the choke. And restart engine.

8.Allow the engine to warm up for a several minutes before starting operation.

NOTE

1.When restarting the engine immediately after stop- ping it, leave the choke open.

2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.

STOPPING ENGINE

[BCZ3200DL][BCZ3200DW]

(3)

(3)

START

(3)Stop switch

1.Release the throttle trigger and run the engine for half a minute.

2.Shift the stop switch to the STOP position.

IMPORTANT

•Except for an emergency, avoid stopping the engine

while pulling the throttle trigger.

GB-10