BCZ3200DL / BCZ3200DW
6. Set up
INSTALLING HANDLE (BCZ3200DL)
•Mount the handle to the shaft tube and clamp it at a location that is comfortable to you.
INSTALLING HANDLE (BCZ3200DW)
1.Loosen the 4bolts on the upper cap and insert the handles equally. Retighten the bolts.
2.Put the handle assembly into the bracket and put the upper cap over it. Tighten the cap securely.
CONNECTING THROTTLE WIRE (BCZ3200DL/DW)
1.Remove the air cleaner cover.
2.Connect the end of the throttle wire to the joint on the top of the carburetor.
CONNECTING SWITCH WIRES (BCZ3200DL/DW)
•Connect the switch wires between the engine and the main unit.
HIP PAD (BCZ3200DW)
•Wrap the hip pad around the shaft tube as shown in the figure, and fasten the hooks.
INSTALLING CUTTING ATTACHMENT GUARD FOR LINE HEAD
• Attach the cutting attachment guard with the bolts pro- vided while inserting the spacer between the guard and the pipe. 
INSTALLING LINE HEAD
1.While locking the gear shaft by inserting the angled bar(1) into the holder(A)(2) on the angle transmission, loosen and remove the nut
2.Fit the line head assembly to the gear shaft. Tighten it securely by hand.
INSTALLING CUTTING ATTACHMENT GUARD FOR METAL BLADE
•When using metal blade, make sure to remove the guard skirt.
BLADE
1.Put the angled bar(1) into the side holes of the holder(A)(2) and the angle transmission.
2.Remove the nut
3.Put the blade onto the holder(A)(2). Make the marked side face the holder.
4.Put the holder(B)(3) onto the gear shaft making the recessed side face the blade.
5.Fasten the blade by the nut and the cover(4).
BALANCE UNIT
1.Put on strap and attach unit to strap.
2.Slide clamp up or down until unit balances with head aparting from the ground when using it.
