8. Operation
NOTE
•This brush cutter can be operated in either the right side or left side position. The rope guide position is fixed for right side position operation when shipped from the factory.
•Adjust the rope guide position as shown in the figure to allow the operator in the
•When changing the position from right to left side, or from left to right side position, be sure to stop the en- gine and place the frame on the ground. Change the orientation of the shaft and carry the frame on the back again.
•Do not change the orientation of the shaft while carry- ing the unit on the back.
Otherwise, accidental injury may occur.
Right side
Rope guide
Left side
Rope guide
BK2651DL
STOPPING ENGINE
1.Release the throttle lever and run the engine for half a minute.
2. Shift the ignition switch to the STOP position. | G |
| B |
IMPORTANT |
|
•Except for an emergency, avoid stopping the engine while pulling the throttle lever.
ADJUSTING THROTTLE CABLE
•The normal play is 1 or 2 mm when measured at the carburetor side end. Readjust with the cable adjuster as required.
(1) | Cable adjuster |
(2) | 0.04in |
(2) |
|
(1) |
|
ADJUSTING IDLING SPEED
1.When the engine tends to stop frequently at idling mode, turn the adjusting screw clockwise.
2.When the cutting head keeps rotating after releasing the trigger, turn the adjusting screw
(1)
(1)Idle adjusting screw (cross screw)
NOTE
• Warm up the engine before adjusting the idling speed.
WARNING
•The product is equipped with a centrifugal clutch mechanism, so the cutting attachment begins to rotate as soon as the engine is started by putting the throttle into the start position. When starting the engine, place the product onto the ground in a flat clear area and hold it firmly in place so as to ensure that neither the cutting part nor the throttle come into contact with any obstacle when the en- gine starts.
