Zenoah EHT601D F5 eHT601D F6 F7, Cutting Work Warning, HOW TO USE HANDLE eHT601D only F5, English

English

5. OPERATION

■CUTTING WORK WARNING

F5 [eHT601D]

F6

F7

•Weather conditions and altitude may effect carburation.

•Do not allow anyone to stay close to the hedge-trimmer while working or while adjusting the carburetor.

■HOW TO USE

HANDLE [eHT601D only] (F5)

To reduce fatigue when trimming hedges, the handle can be swivelled through 90° to the left or right.

Do not press the throttle during this operation!

Proceed as follows:

1.Free the handle by pressing the locking lever.

2.Turn the handle until the locking lever clicks into place.

3.When the handle is locked in its new position, you can apply the throttle again.

(1)Handle

(2)Locking lever

•Use only as much throttle as is needed to do the job. Excessive engine speed is unnecessary.

•Avoid cutting thick branches, for which will damage the blades and shorten the life of drive systems.

•Tilting the trimmer 5 to 10° to the cutting object will make the job easy and bring a good result.

•Always keep your body to the carburetor side of your trimmer, never on the muffler side.

•When a new machine is first operated, in the first few minutes grease may come out of the gear case. But, since this is excess grease, there is no cause for alarm. Just wipe it off with the engine stopped for next use.

26