Zenoah G3200 manual  16 , Operation

7. Operation

F7-11

(1)

F7-12
(3)	(1)	(2)
(4)	(5)	(5)

When the brake engages during operation, immediately release the throttle lever to stop the engine.

■STOPPING THE ENGINE

1.Release the throttle lever to allow the engine to idle for a few minutes.

2.Set the switch to the “O” (STOP) position.

(1) Switch

■CARBURETOR ANTI-FREEZE MECHANISM Operating chain saws in temperatures of 0 – 5°C at times of high humidity may result in ice forming within the carburetor, and this in turn may cause the output power of the engine to be reduced or for the engine to fail to operate smoothly.

This product has accordingly been designed with a ventilation hatch on the right side of the surface of the insulator cover to allow warm air to be supplied to the engine and to thereby prevent icing from occurring.

Under normal circumstances the product should be used in the normal operating mode, i.e., in the mode to which it is set at the time of shipment. However when the possibility exists that icing may occur, the unit should be set to operate in the anti- freeze mode before use.

Stop the engine, remove the cylinder cover and install the grommet A to the appropriate position of the mode.

See ■ Maintenance part for how to remove the cylinder cover.

(1)Normal operation mode

(2)Anti-freeze mode

(3)Insulator

(4)Carburetor (5) Grommet A

16 