SE6
SE7
SE8
English
6. Set up
■CHT2200
1.Attach the engine to the clutch housing of the cutter unit. Casually fix the front 2 points with the screws (.55" long).
2.After connecting the ground wire, install the rear handle to the clutch housing with the screw(2" long) and the nut.
3.Put the screw (1.6" long) through the ground wire terminal and the rear handle, and in to the engine mounting base. Securely tighten all of the engine mounting screws.
4.Attach the front handle onto the gear housing and fasten with 2 screws (1.2" long) and nuts.
5.Connect the throttle cable with the lever on the rear handle, and secure the end with the hardware attached to the handle.
6.Check the cable play and, if necessary, adjust between .04” and .08” by bending throttle wire receiver of the bracket with needle nose pliers.
20
