Zenoah HT2200 manual Operation, Starting Engine, Close

OP1

OP2

OP3

OP4

English

7. Operation

■STARTING ENGINE

WARNING

Keep the blades clear of the surrounding as they will start moving upon starting of the engine.

1.When first starting up after putting fuel into the machine, push the priming pump until fuel runs out in the clear tube. Then close the choke. Choking may not be necessary when re-starting right after stopping the engine. (OP1)

(1)Primer pump

(2)Choke lever

(3)CLOSE

(4)OPEN

2.Pull the throttle lever and push the lock button to set the lever in the START position. (OP2)

(1)Throttle lever

(2)Lock button

3.Slide the ignition switch to the engine side to set it in the ON position. (OP3)

4.Rest the unit on a firm place. Pull the starter knob quickly. (OP4)

NOTE

•Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.

5.When the engine has started, gradually open the choke.

6.Allow the engine to warm up for a half minute before starting operation.

NOTE

•If the engine won't start after several attempts, open the choke and repeat pulling the rope or remove the spark plug and dry it.

28