6. Set up
F1
F2
IMPORTANT
•As a suction hose, be sure to use attached suction hose(nominal diameter 25mm x 3m) or an equivalent ‘water suction hose’ only.
•Securely connect hoses with attached hose couplings and clumps.
•If the suction hose connection is loose, or a packing in hose coupling has been lost or damaged, air may be sucked into the pump and interrupt water suction (air lock).
•A strainer shall be placed so that it does not appear above water level nor suck bottom sand and mud.
1.Place your pump at nearby water resource horizontally.
2.Insert attached hose couplings to the suction hose and discharge hose and tighten them with clumps.
3.After checking the packing of each hose coupling, connect the suction hose to a suction port and the discharge hose to a discharge port.
NOTE
Discharge port angle can be changed to 3 different directions. Adjust to your operating condition.
4.Submerge the suction hose strainer in the water.
5.Lay the discharge hose where necessary. Arrange protective covers if the hose can be disturbed by foot steps of others.
6.Remove
7.Fill up fuel tank with fuel and tighten the tank cap securely. (F2)