7. Operation
F3
F4
■STARTING ENGINE
1.Push a priming pump at lower side of the carburetor several times until you can see the fuel flows into a clear tube. (F3)
2.Put the choke lever to CLOSE position, and set the throttle lever 1/3 to 1/2 open from fully returned position. (F3)
NOTE
Choke lever to OPEN for restarting immediately after stopping engine.
3.Confirm that the machine is stable on the ground. While holding the plug guard with your left hand, pull the starter knob with right hand. Starter knob shall be initially pulled gently, then vigorously when you feel resistance. (F4)
IMPORTANT
Avoid pulling out entire length of the rope or free returning of rope by releasing the knob. Doing this may cause starter failure.
NOTE
In case the engine does not start due to excess fuel, fully open the choke and throttle levers and repeat pulling the rope. Or take out the spark plug to dry and repeat the procedure.
4.When the engine is started, gradually open the choke lever, also return the throttle lever, and allow the engine 2 to 3 minutes of warming up at a low speed.
5.Operate the engine at a half throttle until the water in suction hose reaches the pump. As water discharge is started, adjust the throttle according to your required flow rate within the capacity.
