Zenoah PSZ2600 GB-6, Starting the Engine, Using the Product, If Someone Comes, Maintenance

PSZ2600

5. For safe operation

IMPORTANT

Remove any obstacle before beginning work.

4.Inspect the entire unit for loose fasteners and fuel leakage. Make sure that the cut- ting attachment is properly installed and securely fastened.

5.Always use the shoulder strap. Ad- just the strap for comfort before start- ing the engine. The strap should be adjusted so the left hand can com- fortably hold the handlebar grip ap- proximately waist high.

STARTING THE ENGINE

1. Keep bystanders and animals at least

15 m away from the operating point. If you are approached, immediately stop the engine.

2. The product is equipped with a cen- trifugal clutch mechanism, so the cut- ting attachment begins to rotate as soon as the engine is started by put- ting the throttle into the start position. When starting the engine, place the product onto the ground in a flat clear area and hold it firmly in place so as to ensure that neither the cutting part nor the throttle come into contact with any obstacle when the engine starts.

WARNING

Never place the throttle into the high- speed position when starting the engine.

3.After starting the engine, check to make sure that the cutting attachment stops rotating when the throttle is moved fully back to its original posi- tion. If it continues to rotate even after the throttle has been moved fully back, turn off the engine and take the unit to your authorized ZENOAH ser- vicing dealer for repair.

USING THE PRODUCT

IMPORTANT

Cut only materials recommended by the manufacturer. And use only for tasks ex- plained in the manual.

1.Grip the handles firmly with both hands using your whole hand. Place your feet slightly apart (slightly further apart than the width of your shoulders) so that your weight is distributed evenly across both legs, and always be sure to maintain a steady, even posture while working.

2.Maintain the speed of the engine at the level required to perform cutting work, and never raise the speed of the engine above the level necessary.

3.Never operate the pruner at an angle greater than 60° in order to reduce the risk of being struck by falling objects during operation.

4.If the unit starts to shake or vibrate, turn off the engine and check the whole unit. Do not use it until the trouble has been properly corrected.

5.Keep all parts of your body away from rotating cutting attachment and hot surfaces.

6.Never touch the muffler, spark plug, or other metallic parts of the engine while the engine is in operation or

immediately after shutting down the engine. Doing so could result in seri- ous burns or electrical shock.

•IF SOMEONE COMES

1.Guard against hazardous situations at all times. Warn adults to keep pets and children away from the area. Be careful if you are approached. Injury may result from flying debris.

2.If someone calls out or otherwise in- terrupts you while working, always be sure to turn off the engine before turn- ing around.

MAINTENANCE

1. In order to maintain your product in proper working order, perform the maintenance and checking opera- tions described in the manual at regu- lar intervals.

2.Always be sure to turn off the engine before performing any maintenance or checking procedures.

WARNING

The metallic parts reach high temperatures immediately after stopping the engine.

3.When replacing the cutting attach- ment or any other part, or when re-

placing the oil or any lubricant, always be sure to use only ZENOAH prod- ucts or products which have been certified by ZENOAH for use with the ZENOAH product.

4.In the event that any part must be re- placed or any maintenance or repair work not described in this manual must be performed, please contact a representative from the store nearest ZENOAH authorized servicing dealer for assistance.

5.Do not use any accessory or attachment other than those bearing the ZENOAH mark and recommended for the unit.

6.Under no circumstances should you ever take apart the product or alter it in any way. Doing so might result in the product becoming damaged dur- ing operation or the product becom- ing unable to operate properly.

GB-6