Zenoah SGCZ2600DW Harness, HOW to Wear, Balance the Unit, Quick Release, Usage, HOW to USE

8. Operation

HARNESS

WARNING

ALWAYS WEAR THE PROVIDED HARNESS WHEN USING THE MACHINE!

Always make sure the machine is hooked securely to the harness.

If you don't, you will be unable to control the machine safely. This can result in injury to yourself or others. Never use a harness with a defective quick release or any other damage.

HOW TO WEAR

1.Wear the provided harness without twisted bands, with the hanger on your right side.

(1)

(DL: Single strap) (DW: Double strap)

(1) Hanger (1)

BALANCE THE UNIT

1.Hook your machine to the hanger.

2.Adjust the bands of the harness to have the blade parallel to the ground when standing in your normal working position to provide you most effectiveness and comfort on operating the machine.

3.In order to prevent the hanger position to change during operation, turn up the extra part of the band from the buckle.

4.When correctly adjusted, check the correct working of the harnesses' QUICK RELEASE.

QUICK RELEASE

The harness is equipped with a "QUICK RELEASE"devise. To release the machine from the harness in emergency situations, please follow the procedure as explained below.

WARNING

Make sure to check proper working of the QUICK RE- LEASE device BEFORE operating the machine. Make sure to hold the unit securely when using the

QUICK RELEASE.

(DL)

While holding the unit by your right hand securely, press both

sides of the	(1)
buckle. sides of the buckle.
(1) Buckle	(DL: Single strap)

SGCZ2600DL/SGCZ2600DW

(DW)
While holding the unit by your left
hand securely, press the red button
of the buckle.
Then take the harness off from your	G
shoulders.
	(1)
	B
(1) Buckle
	(DW: Double strap)

USAGE

This machine does cutting not by a rotary cutter like con- ventional trimmers but by a pair of special blades, each upper blade and lower blade oscillate opposite direc- tion alternately within a limited angle at a speed of ap- proximately 1/30 of conventional trimmers.

This unique mechanism brings you many benefits like the following:

1.Since the blade does not cause grass chips and pebbles to the thrown around, you may use less care about your clothing or surroundings.

2.Should the blade hit a rigid object like stones, trees or steel poles during operation, it does not produce a bounce motion that can cause loss of machine con- trol.

3.Since the blade does not cause cut grass to wrap around the neck, you need not to stop operation to remove such wrappers.

What's more, since the whole circle of the blade is avail- able for cutting, you can move the cutting head in all di- rections and cut grass growing on such place difficult-to- get with conventional trimmer.

You can even trim the waterside without splashing water.

HOW TO USE

•Adjust the front handle to the most comfortable position.

•Start the engine and pull the throttle trigger gradually. The blades will start moving as the engine speed goes up.

•To stop the blade motion, simply release the throttle trigger. The clutch will disengage and the blades stop moving while the engine keeps idling.

•Move the cutting head as sliding its bottom on the ground. This will help you do the job with less effort.

NOTE

a)Avoid running the engine at full throttle with no load. Continuous no load full throttle operation can cause damage to the engine and the drive shaft.

b)Operation at too slow engine speed can cause ab- normal vibration of the machine, resulting in short life of drive shaft and clutch parts. If you felt such vibra- tion, use a higher speed range.

c)Though the blades are made of steel harder than con- ventional metal blades, continuous cutting in soil will accelerate wear.

GB-11