5. Replace the 6 wing nuts, tightening only the two at the front and leaving the other 4 loose. Fig.4
6. Close the door carefully un- til it latches.
- Check for correct alignment:
the side edges have to be aligned, and the distance between the top se- cured glass and the lower glass should be approximately 1/16” across the whole width. Fig. 5
- If the glass is po-
sitioned | correctly | min 1/16" |
you may | continue |
to step 9, otherwise please continue to the next stage.
7.Open the door again, then loosen
the 2 front wing nuts and adjust the alignment by sli- ding the glass.
8. Tighten the 2 front wing nuts and try closing the door again.
Please Note! If the alignment is still not correct, repeat the procedure from step 7.
9.Open the door and tighten the 4 remaining nuts. Now the glass has been fully secured to the hood.
Installation instructions
- 3 -
