McIntosh MCC602TM manual How to Connect for Two Channels

How to Connect for Two Channels

1.Connect the power control cable from the Control Cen- ter Amp ON to the MCC602TM ON Connector on the

right side of the Amplifier.

Note: All cables should be connected to the amplifier before connecting the DC power cables to the battery.

2.Connect a cable from a McIntosh Control Center with Power Guard to the MCC602TM PG Connector on the right side of the amplifier.

3.Connect the CHANNEL 1 4(-) Ohm OUTPUT of the Power Amplifier to the Crossover Network Negative (-) Input Terminal and the CHANNEL 1 4(+) Ohm OUTPUT to the Crossover Network (+) Input Termi- nal. Connect the CHANNEL 2 OUTPUTs to the sec- ond Crossover Network in a similar manor.

4.Connect the cables from the Crossover Network to the respective Woofer/Midrange Terminals, for both chan- nels.

5.Connect the cables from the Crossover Network to the Tweeter Terminals, for both channels.

6.Connect audio cables from the Control Center Front Outputs to the appropriate MCC602TM Inputs.

7.Connect the MCC602TM DC input terminals on the left side of the amplifier to the vehicle battery termi-

nals using a minimum size of 4 AWG cables.

Note: It is advisable to place an in-line fuse as close as possible to the battery.

Left Tweeter Left Woofer/Midrange

McIntosh Control Center

Left Front Output

Right Front Output

Power Guard

(orange) Amp ON

(blue/white)

8