- Make 4, holes in the ceiling and drive in
(3) screws without completely tighte- ning them. Pay attention not to insert the screw into the hole marked with an X on the hole template Fig.7
6. Lift the hood assembly to the cei- ling and align the top support fra- me with the (3) screws previously installed in the ceiling.
- Rotate assembly slightly clockwise to lock in place. Fig.8A. Drive in the fourth screw and tighten the remaining 3 screws to secure the structure in place. Fig.8B
7. Extend the upper duct cover and secure it to the top support frame by using (2) screws. Fig.9
8. Verify that ducting from hood is connected to ducting in the attic that will exhaust air out of the home.
Installation - Mounting the Duct Cover
- 5 -