Zephyr ZMI-M90S Features & Controls, Touch Controls & Features, Blower On/Off, Speed Selection

6

FEATURES & CONTROLS

TOUCH CONTROLS & FEATURES

1Blower On/Off

5Display (Speed level, Delay Off Indicator, Filter Clean/ Change)

4 Lights On/Off/ Hold to Dim

2 Adjust 6 Speed Levels 3 15 Min Delay Off

1Blower On/Off

By pressing , the blower is switched On and Off. When switched on, the blower starts up on speed level 3.

2Speed Selection

The 6 speed levels are selected by pressing to decrease and to increase speed level. The display indicates level selected.

3Delay Off

This is used for programmed shut down of blower and lights 15 minutes after the function is

activated. Press once, a dot flashes in the lower right hand side of display indicating the function is on. The hood will completely shut down in 15 minutes.

4Lights On/Off/ Dim

Switch lights On and Off by pressing key once. To dim lights, press and hold- for 2 seconds.

5Advance Display Functions

Filters Clean Reminder (Metal):

After every 30 hours of use, the display will start flashing an reminding you to clean the metal filters from residue and possible clogs.

The standard Metal Filters fitted are required to be cleaned frequently and as recommended in order to maintain blower efficiency. If improperly maintained, residue from cooking will sift through filters and cause damage to hood blowers and other sensitive components; and possibly clog duct work and creates fire hazard.

Filters Change Reminder (Carbon, if fitted):

When your hood is installed as a 'Purifying' (Ductless Recirculating) unit, it is fitted with a set of Carbon Filters to purify exhaust and fumes from cooking, and re-circulates the air within the home. These Carbon Filters are required to be replaced after every 120 hours of use. The Filter Change Reminder function in the microprocessor needs to be switched on. The microprocessor in the controls when set, will elapsed and count usage time and indicate when carbon filter replacement is needed every 120 hrs.