4Owner's Manual
There are two thumb screws beneath the bridge. The bridge may be raised or lowered on both sides to accommodate your playing style. It is recommended that the strings be slightly loosened before making any adjustments. Do not use pliers on the thumbscrews as the instrument's finish and screws may be damaged. Also, intonation may be adjusted by changing the angle at which the bridge meets the strings.
DOUBLE ADJUSTING TRUSS ROD
The truss rod is located where the neck meets the body. Turning the truss rod clockwise adds tension and
BATTERY
This instrument contains quiet pre
TROUBLESHOOTING
Don’t Panic!
No Output
1.Try increasing volume.
2.Try using a different ¼" cable.
3.Try replacing the internal
String(s) Dead or Low Level Output
1.Check to see if the string is sitting properly on the bridge.
2.Check to ensure that the steel ball at the end of the string is in good contact with the tailpiece. If necessary, scrape away any thread winding on the string that may be preventing a clean
3.Try replacing the internal
4.Try raising the internal volume of the affected string(s).
Hum, Hiss or Distortion
1.Try using a different ¼" cable.
2.Your amplifier may not be properly grounded. If your amplifier has a "ground reverse" or "ground lift" switch, try changing it's position.
RETURNING UNITS FOR SERVICE
If your unit requires service, please follow these steps:
1.Contact your authorized Zeta Dealer for a Return Authorization (RA) number.
2.Pack the unit in its original carton with packing materials.
3.Please include a note with the following information:
a.A brief explanation of the problem you are experiencing.
b.Your full contact information: Full name, street address, city, state, zip, country (if not USA), phone number(s), and email address.
c.Copy of your original purchase receipt.
3.Write the RA number on the outside of the shipping container. Shipments sent to ZETA without an RA number are refused.
Zeta Music