ZETA Music Systems XB-306 manual Instrument Care, Bridge Adjustments, Truss ROD, Battery

Owner's Manual 5

ZETA XBS-6 CrossOver Bass Strings, High Finish Ribbon Wound, Soft Gauge, Long

Scale (34"):
C: 0.82mm/0.32 inch	G: 1.14mm/.045 inch	D: 1.65mm/.065 inch
A: 2.03mm/.080 inch	E: 2.54mm/.100 inch	B: 3.35mm/.132 inch

ZETA strings are available at your Authorized ZETA Dealer. ZETA strings are manufactured in collaboration with the D'Addario String Company.

INSTRUMENT CARE

CLEANING. Do not clean your instrument with chemical solvents such as benzene or alcohol. Wipe only with a clean dry cloth or use a high quality non-abrasive instrument polish.

SET UP. ZETA recommends that you have your neck adjusted seasonally by a qualified instrument repair person or luthier, or at your local Authorized ZETA Dealer.

BRIDGE ADJUSTMENTS

There are two thumb screws beneath the bridge. The bridge may be raised or lowered on both sides to accommodate your playing style. It is recommended that the strings be slightly loosened before making any adjustments. Do not use pliers on the thumbscrews as the instrument's finish and screws may be damaged. Also, intonation may be adjusted by changing the angle at which the bridge meets the strings.

TRUSS ROD

The truss rod is located where the neck meets the body, and is recessed inside of the neck. An allen wrench extension may be necessary to adjust the truss rod on some models of Cross-Over™ Bass. Turning the truss rod clockwise adds tension and up- bow to your neck; turning the truss rod counter-clockwise relieves tension and adds down-bow to your neck. We recommend that you have your neck adjusted seasonally by a qualified instrument repair person or luthier, or at your local Authorized ZETA Dealer.

BATTERY

This instrument contains quiet pre-amplified electronics within the compartment on the back of the instrument. A 9-volt battery powers the circuitry and should be changed after 1,000 hours of playing use. Plugging in the ¼" cable activates the preamp. When

Zeta Music