ZyWALL 10
Hardware Installation
Rear Panel
| LABEL | DESCRIPTION |
|
|
|
1. | 10/100M LAN | Connect a computer to this port with an Ethernet cable. This port is |
|
| connect at 10 or 100Mbps). Push the UPLINK button in with a |
|
| have the UPLINK button out with a crossover Ethernet cable. |
2. | 10 WAN | Connect your cable/DSL modem to this port with the Ethernet cable that came with your modem. |
|
|
|
3. | POWER 12VDC | Connect the included power adaptor (use only this adapter) to this power socket. |
|
|
|
| After you’ve made the connections, connect the power cable to a power supply and look at the front panel LEDs. | |
|
| |
CONSOLE | Only connect this port if you want to configure the ZyWALL using the SMT via console port; see | |
|
| your User’s Guide for details. |
|
| Connect the male end of the console cable to the console port of the ZyWALL and the other end |
|
| to a serial port (COM1, COM2 or other COM port) on your computer. Your computer should have |
|
| a terminal emulation communications program (such as HyperTerminal) set to VT100 terminal |
|
| emulation, no parity, 8 data bits, 1 stop bit, no flow control and 9600 bps port speed. |
|
|
|
2