ZyWALL 10W Internet Security Gateway

Hardware Installation

Rear Panel and Connections

Connect a grounded wire to ground the ZyWALL.

Reset to

 

default

Connect to

configuration

file. See User’s

your cable/DSL

Guide.

modem.

 

 

Connect to a computer/hub using a straight-through/ crossover Ethernet cable.

The computer must have

Ethernet NIC (Network

Interface Card) installed.

Use a Y-cable to connect your administration computer or a modem (with a cable converter) to the CON/AUX port.

Make sure the CON/AUX switch is pushed to the appropriate side.

Turn off your ZyWALL. Remove the protective cover plate from the slot and insert an optional PCMCIA wireless LAN card into the slot.

Never force, bend or twist the wireless LAN card into the slot.

The wireless LAN is disabled by default. The ZyWALL wireless LAN may not work if you do not use ZyAIR wireless PC cards.

Do this last. Connect to a power source using the supplied power adapter.

The Front Panel

Refer to the User’s Guide for LED descriptions.

The PWR and CON/AUX LEDs turn on. The SYS LED blinks and turns steady on. The SYS LED turns red if power is too low. The LAN, WAN and WLAN LEDs turn on, if they are properly connected.

2