ZyWALL 30W

Hardware Installation

Rear Panel

LABEL

DESCRIPTION

1.LAN 10/100M Connect a computer to this port with an Ethernet cable. This port is auto-negotiating (can connect at 10 or 100Mbps) and auto-sensing (automatically adjusts to straight-through or crossover Ethernet cable).

2.WAN 10/100M Connect your cable/DSL modem to this port with the cable that came with your modem.

3. POWER 12VDC Connect the included power adaptor (use only this adaptor) to this power socket.

After you’ve made the connections, connect the power cable to a power supply and look at the front panel LEDs.

CON/AUX switch

Only connect this port if you want to configure the ZyWALL using the SMT via console port or set

CON/AUX port

up a backup WAN connection; see your User’s Guide for details.

 

Set this switch to the “CON” side to use the CON/AUX port as a console port for local device

 

configuration and management. Connect the 9-pin male end of the console cable to the console

 

port of the ZyWALL and the other end to a serial port (COM1, COM2 or other COM port) on your

 

computer. Your computer should have a terminal emulation communications program (such as

 

HyperTerminal) set to VT100 terminal emulation, no parity, 8 data bits, 1 stop bit, no flow control

 

and 9600 bps port speed.

 

Set this switch to the “AUX” side to use the CON/AUX port as an auxiliary dial-up WAN

 

connection. Use the included CON/AUX converter, with the console cable to connect the

 

CON/AUX port to your modem or TA.

RESET

You only need to use this button if you’ve forgotten the ZyWALL’s password. It returns the

 

ZyWALL to the factory defaults (password is 1234, LAN IP address 192.168.1.1, terminal

 

emulation settings as described above etc.; see your User’s Guide for details).

 

 

2