Chapter 4 ZyXEL Utility Configuration
Figure 31 Adapter: WMM Advanced Setting
The following table describes the labels in this screen.
Table 16 Adapter: WMM Advanced Setting
LABEL | DESCRIPTION |
Select this option to extend the battery life of your mobile devices (especially | |
Save Enable | useful for small devices that are running multimedia applications). The |
| goes to sleep mode to save power when it is not transmitting data. The AP buffers |
| the packets sent to the |
| periodically to check for incoming data. |
| Note: This works only if the wireless device to which the |
| connected also supports this feature. |
|
|
Direct Link | Select this option to enable DLS (Direct Link Setup) on the |
| two |
| devices to communicate with each other directly. The packets will not go through |
| the AP and can increase throughput. |
| You need to enter the peer device’s MAC address in this screen. |
| The |
| enter one device’s MAC address in the |
| up a second DLS connection, enter the |
| device. |
| Note: This feature is applicable only when the |
| Infrastructure mode and the connected AP or wireless router |
| is also |
|
|
MAC Address | Enter the MAC address of the peer device that supports DLS. |
|
|
Timeout Value | Enter the time in seconds (from 1 to 65535) for the |
| automatically disconnects from the peer device when there is no traffic between |
| them. |
|
|
Apply | Click Apply to save your changes in this section. |
|
|
Direct Link Status |
|
| 47 |
|
|